How to Put on and Remove an Ultra Thin Case

If you have just bought a new phone, you will most likely be using a case to protect it. Which means you will have to find out at some stage how to put on and remove your case. Normally, putting on a phone case is quite straightforward, but with a form-fitted case, it is quite tricky to do so. So now we will go through with you how-to do it step by step.

1. Slide in your phone into the top left hand corner of the case and align the buttons with the cut-out holes.
   
2. Align the phone with the case and press down the phone into the lower left corner
   
3. Press down the other two reamining corners, one at a time
   

At some point of time, you might want to clean your phone and you will need to remove the case. With such a tight-fitting case, you will have to follow the steps below to remove it.

1. Hold the phone tightly with one hand, and use your thumb of the other hand and push the top left-hand corner of the case out
   
2. Repeat Step 1 on the top-right hand corner of the case.
   
3. Gently slide the phone upwards to remove the case
   

Extra Tip:

1. If the button got stuck outside the cut-outs of the case, slide a thin card into the side of the case and slowly slide along the side of the case.